Electric vehicles work well for short trips between places where you can charge with cheap electricity. Typically that’s trips from home to a nearby place of work, and to local shopping malls and theaters with low-cost charge spots. If you drive this way, you’ll pay about 3.2¢/mile for home electricity, instead of about 17¢/mile for gasoline transport (e.g. 24 mpg with $4/gallon gas). Using an EV also saves on oil changes, transmission, air filters, belts, etc., and a lot of general complexity. Battery prices are still high, but much lower than they were even a few years ago.

EVs are less attractive for long trips, especially in the cold. Your battery must provide the heat, as there is no waste heat from the engine. Expect to have to recharge every 200 -250 miles, or perhaps twice in the middle of a long trip. Each charge will take a half-hour or more, and fast charging on the road isn’t low cost. Expect to pay about 15¢/mile, nearly as much as for gasoline. See my full comparison of the economics here.

One obvious solution is to have two cars: a short commuter and an EV. Another solution is a hybrid. The Toyota’s Prius and the Chevy Volt were cutting edge in their day, but people don’t seem to want them. These older hybrids provided quick fill-ups, essentially infinite range, and about double the gas milage of a standard automobile, 30-45 mpg. The problem is you have even more complexity and maintenance than with even a gas automobile.

I recently saw a small, simple, super-efficient (they say) gas engine called Aquarius. It provides 9.5 kW electric output and weighs only 22 lbs (10 kg), see picture above. A Tesla S uses about 16 kW during highway driving, implying that this engine will more than double the highway range of a Tesla S at minimal extra weight and complexity. It also removes the fear of being stranded on the highway, far from the nearest charge-station.

The energy efficiency is 34%, far higher than that for normal automobile engines, but fairly typical of floating piston linear engines. The high efficiency of these engines is partly due to the lack of tapper valves, risers, crank-shaft, and partially due to the fact that the engine always runs at its maximum power. This is very close to the maximum efficiency point. Most car engines are over sized (200 hp or so) and thus must run at a small fraction of their maximum power. This hurts the efficiency, as I discuss here. The Aquarius Engine makes electricity by the back-forth motion of its aligner rods moving past magnetic stator coils. Slots in the piston rod and in the side of the cylinder operate as sliding valves, like in a steam engine. First versions of the Aquarius Engine ran on hydrogen, but the inventors claim it can also run on gasoline, and presumably hythane, my favorite fuel, a mix of hydrogen and natural gas.

A video is available to show the basic operation (see it here). The drawing at right is from that video, modified by me. Air is drawn into the engine through a sliding valve at the middle of the cylinder. The valve opens and closes depending on where the piston is. At the instant shown in the picture, the valve is open to the right. Air enters that chambered is likely exiting through slits in the hollow piston rod. It leaves through the manifold t the top, pushing exhaust along with it. When the piston will have moved enough, both the slits and the intake will close. The continued piston motion (inertially driven) will compress the air for firing. After firing, the piston will move left, generating electricity, and eventually opening the slit-valve in the piston to allow the exhaust to leave. When it moves a little further the intake will open.

The use of side-opening exhaust valves is a novelty of the “Skinner UniFlow” double-acting, piston steam engines, seen on the Badger steamship on Lake Michigan. It’s one of my favorite steam engine designs. Normally you want a piston that is much thicker than the one in the drawing. This option is mentioned in the patent, but not shown in the drawing.

Aquarius is not the only company with a free-piston range extender. Toyota built a free-piston extender of similar power and weight; it was more complex but got higher efficiency. It has variable compression though, and looks like a polluter. (the same problems might affect the Aquarius) They dropped the project in 2014. Deutsch Aerospace has a two headed version that’s more powerful, but long and heavier: 56kg and 35kW. Lotus has a crank-piston engine, also 56kg, 35kW; it’s more complex and may have service life issues, but it’s compact and relatively light, and it probably won’t pollute. Finally, Mazda is thinking of bringing back its Wankel rotary engine as a range extender. Any of these might win in the marketplace, but I like the Aquarius engine for its combination of light weight, compact size, and simplicity.

This is not to say that Aquarius motors is a good investment. Aquarius automotive went public on the Toronto exchange in December, 2021, AQUA.TA. The company has no profits to date, and the only chance of them making a profit resides in them getting a good licensing deal from an established company. The major car companies have shown no interest so far, though they clearly need something like this. Their plug in hybrids currently use standard-size, 4 stroke engines: 110-150 kW, 100-150 kg, complex, and low efficiency. Consumers have not been impressed. Tesla autos could benefit from this engine, but Musk shows no interest either.

Robert Buxbaum May 5, 2022. I have no stock in Aquarius motors, nor have I received any benefits from them, or any auto company.